COMPONENT ACCESS (Cont.)
4-16
n
Whirlpool
®
24" Compact Condensing Dryer
6.
Lift up grey pad and squeeze hose clamp with pliers and pull
up on hose (see Figures 3).
Figure 3
7.
Remove rear access panel, hose, and grey pad (see
Figure 4).
Figure 4
8.
Remove five (5) T20 screws as shown in Figure 5.
Figure 5
9.
Remove plastic water sensor and drain pump support
bracket by lifting up on it (see Figure 6).
Figure 6
10.
Remove the foam tape from Water Level Sensor (see
Figure 7).
Figure 7
11.
Remove the T20 screw securing the Water Level Sensor and
disconnect wire connector (see Figure 8).
Figure 8
NOTE:
When replacing the water level sensor make sure to
remove all water from tray to ensure proper calibration.
