COMPONENT ACCESS (Cont.)
4-2
n
Whirlpool
®
24" Compact Condensing Dryer
Removing the Door Assembly and Door Components
To Remove the Door Assembly
1.
Open door (see Figure 1).
Figure 1
2.
Use a TORX
®†
T-20
®
driver to remove the two (2) hinge
screws (see Figure 2).
Figure 2
3.
Lift up door assembly to disengage hinge from the front
panel. Remove door assembly (see Figure 3).
Figure 3
†®TORX and T-20 are trademarks of Acument Intellectual Properties, LLC.
To Remove the Door Strike Assembly
1.
Open door (see Figure 1).
Figure 1
2.
Using a flat-blade screwdriver, insert the screwdriver as
shown in Figure A below. At the same time, push down on
the strike until it unclips from the door (see Figure B).
Remove the strike assembly from the door.
Figure A
Figure B
WARNING
Electrical Shock Hazard
Disconnect power before servicing.
Failure to do so can result in death or
electrical shock.
Replace all parts and panels before operating.
