15
Tighten couplings
3.
Using pliers, tighten the couplings with additional two-thirds turn.
noTE:
Do not overtighten. Damage to the coupling can result.
A
B
Attach long hose to “Y”
connector and tighten couplings
4.
One end of the long hose has
a wire mesh strainer inside the
coupling. Attach this end to the “Y” connector. Attach washer
cold inlet hose to other side of “Y” connector. Screw on coupling
by hand until it is seated on connector. Using pliers, tighten the
couplings an additional two-thirds turn.
noTE:
Do not overtighten. Damage to the coupling can result.
Attach long hose to dryer fill
valve and tighten coupling
5.
Attach other end of long hose to fill
valve at bottom of dryer back panel.
Screw on coupling by hand until it
is seated on fill valve connector.
Using pliers, tighten the couplings an additional two-thirds turn.
noTE:
Do not overtighten. Damage to the coupling can result.
Turn on cold water faucet
6.
Check that the water faucets are turned on.
Check for leaks
7.
Check for leaks around “Y” connector, faucet, and hoses.
CONNECT vENT
Connect vent to exhaust outlet
1.
Using a 4" (102 mm) clamp, connect vent to exhaust outlet in
dryer. If connecting to existing vent, make sure vent is clean.
Dryer vent must fit over dryer exhaust outlet and inside exhaust
hood. Check that vent is secured to exhaust hood with a
4" (102 mm) clamp.
