20
4.
Turn gas pressure regulator cap counterclockwise with a 5/8"
(1.6 cm) combination wrench to remove.
NOTE:
Do not remove the spring beneath the cap.
A. Plastic cover
B. Gas pressure regulator cap with solid end facing out
C. Gas pressure regulator cap with hollow end facing out
D. Washer
E. Gas pressure regulator cap
5.
Turn over the gas pressure regulator cap and reinstall on
regulator so that the hollow end faces out and the marking
“↓LP” is facing the direction shown in the above drawing.
6.
Replace plastic cover over gas pressure regulator cap.
To Convert Surface Burners (Natural Gas to
Propane Gas)
1.
Remove burner cap.
2.
Remove the burner base.
A. Igniter electrode
B. Burner cap
C. Gas tube opening
D. Burner base
3.
Apply masking tape to the end of a 9/32" (7 mm) nut driver to
help hold the gas orifice spud in the nut driver while changing
it. Press nut driver down onto the gas orifice spud and remove
by turning it counterclockwise and lifting out. Set gas orifice
spud aside.
A. Igniter electrode
B. Orifice spud
C. Orifice spud holder
D. Screws
4.
Remove the orifice spuds shipped in the literature package in
the oven. Gas orifice spuds are stamped with a number on the
side. Replace the Natural gas orifice spud with the correct
Propane gas orifice spud.
A. Stamped number
Refer to the following chart for correct Propane gas orifice spud
ratings and to spud holder card for proper placement.
Propane Gas Orifice Spud Chart for Surface Burners
Burner
Rating/Type
Color
Size
(mm)
ID
Number
Placement
13,500 BTU
1.06
106AM
LF
4,500 BTU
0.61
061AM
LR
12,000 BTU
1.01
101AM
RF
7,500 BTU
Red/Blue
0.80
080AM
RR
10,000 BTU
0.96
096AM
CTR
*Not in all kits/models.
NOTE:
Refer to the model/serial/rating plate located on the oven
frame behind the top right-hand side of the oven door for proper
sizing of spuds for each burner location.
5.
Place Natural gas orifice spuds in the orifice spud bag.
IMPORTANT:
Keep the Natural gas orifice spuds in case of
reinstallation with Natural gas.
6.
Replace the burner base.
7.
Replace burner cap.
8.
Repeat steps 1-7 for the remaining burners.
To Convert Oven Bake Burner (Natural Gas to
Propane Gas)
1.
Remove the oven racks and the oven door. See the “Oven
Door” section.
2.
Remove two screws and washers at the rear of the oven
bottom.
3.
Lift the rear of the oven bottom up and back until the front of
the panel is away from the front frame. Remove from oven
and set it aside on a covered surface.
A. Screws
B. Oven bottom
