66
The Clean Washer with affresh message will flash at the end of
a wash cycle when the washer has run 30 wash cycles This is
a reminder to run the Clean Washer with affresh cycle.
If the Clean Washer with affresh cycle is not run, the message
will stop flashing at the end of a wash cycle after running three
more regular wash cycles. After 30 more wash cycles are
completed, the Clean Washer with affresh message will again
flash at the end of a wash cycle as a reminder.
CLEAN WASHER CYCLE REMINDER
Replace inlet hoses after 5 years of use to reduce the risk
of hose failure. Periodically inspect and replace inlet hoses
if bulges, kinks, cuts, wear, or leaks are found.
When replacing your inlet hoses:
■
Mark the date of replacement on the label with a
permanent marker.
■
Check that the old washer is not stuck on the
washer/dryer inlet valve.
■
Use new washers in the new inlet hoses to ensure a
proper seal.
WATER INLET HOSE
REMOVING THE LOAD & GO
BULK CONTAINER
To remove:
1.
Lift the bulk container lid on the top of the washer/dryer.
2.
Lift up on the bulk container handle and pull straight up
and out of the washer/dryer.
To replace:
1.
Place the bulk container back into the bulk container
cavity on the top of the washer/dryer and make sure
that it is seated.
2.
Close the bulk container lid.
If moving, or not using your washer/dryer for a period
of time, follow these steps:
1.
Unplug or disconnect power to washer/dryer.
2.
Turn off water supply to washer/dryer to avoid flooding
due to water pressure surges.
HELPFUL TIP:
Attach a reminder note to the washer/
dryer to turn the water back on before washer’s next use.
3.
Clean the bulk dispenser. See “Cleaning the Load & Go
Bulk Dispenser.”
NON-USE AND VACATION CARE
WINTER STORAGE CARE
IMPORTANT:
To avoid damage, install and store washer/
dryer where it will not freeze. Because some water may stay
in hoses, freezing can damage washer/dryer. If storing or
moving during freezing weather, winterize your washer/dryer.
To winterize washer/dryer:
1.
Shut off water faucet, disconnect and drain water
inlet hose.
HELPFUL TIP:
Attach a reminder note to the washer/
dryer to turn the water back on before washer’s next use.
2.
Remove drain pump filter.
3.
Put 1 qt. (1 L) of R.V.-type antifreeze in drum and run
washer/dryer on Normal cycle for about 2 minutes to
mix antifreeze and remaining water.
4.
Unplug washer/dryer or disconnect power.
