10
3.
Use a 15/16" (2.4 cm) combination wrench and adjustable
wrench to attach the flexible connector to the adapters.
Check that connector is not kinked.
Complete Connection
1.
Check that the gas pressure regulator shutoff valve is in the
“on” position.
2.
Open the manual shutoff valve in the gas supply line. The
valve is open when the handle is parallel to the gas pipe.
3.
Test all connections by brushing on an approved
noncorrosive leak-detection solution. If bubbles appear, a
leak is indicated. Correct any leak found.
4.
Remove cooktop burner caps and grates from parts
package. Burner caps should be level when properly
positioned. If burner caps are not properly positioned,
surface burners will not light. Place burner grates over
burners and caps.
5.
Plug into a grounded 3 prong outlet.
6.
Slide range into final location, making sure the rear leveling
leg slides into the slot of the anti-tip bracket.
Verify Anti-Tip Bracket Is Installed and
Engaged
On Ranges with a Storage Drawer:
1.
Remove the storage drawer. See “Storage Drawer” section.
2.
Use a flashlight to look underneath the bottom of the range.
3.
Visually check that the rear range foot is inserted into the slot
of the anti-tip bracket.
On Ranges with a Warming Drawer or Premium Storage
Drawer:
1.
Place the outside of your foot against the bottom front of the
warming drawer or premium storage drawer, and grasp the
lower right or left side of the control panel as shown.
NOTE:
If your countertop is mounted with a backsplash, it
may be necessary to grasp the range higher than is shown in
the illustration.
2.
Slowly attempt to tilt the range forward.
If you encounter immediate resistance, the range foot is
engaged in the anti-tip bracket.
3.
If the rear of the range lifts more than 1/2" (1.3 cm) off the
floor without resistance, stop tilting the range and lower it
gently back to the floor. The range foot is not engaged in the
anti-tip bracket.
A
B C
D
E
F
G
H
A. Gas pressure regulator
B. Use pipe-joint compound.
C. Adapter (must have 1/3"
[1.2 cm] male pipe thread)
D. Flexible connector
E. Manual gas shutoff valve
F. 1/2" (1.3 cm) or 3/4" (1.9 cm)
gas pipe
G. Use pipe-joint compound.
H. Adapter
A
A. Gas pressure regulator shutoff valve shown
in the “on” position
A
B
A. Closed valve
B. Open valve
C
A
B
A. Burner base
B. Burner cap
C. Burner grate
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
