25
4.
Replace the “090” hood with a “53” hood. Install the Natural
gas broiler burner orifice hood, turning it clockwise until snug.
IMPORTANT:
Do not overtighten.
A. Orifice hood
5.
Place the broil burner on the broil burner orifice hood and
insert the broil burner ceramic igniter in the hole in the rear of
the oven.
6.
Position the broil burner against the top of the oven and attach
it with 2 screws.
7.
Replace storage drawer or warming drawer. See the “Storage
Drawer” or “Warming Drawer or Premium Storage Drawer”
section.
8.
Replace the oven door. See the “Oven Door” section.
9.
Replace the oven racks.
Complete Installation (Propane Gas to Natural
Gas)
1.
Refer to the “Make Gas Connection” section for properly
connecting the range to the gas supply.
2.
Refer to the “Electronic Ignition System” section for proper
burner ignition, operation and burner flame adjustments.
IMPORTANT:
You may have to adjust the “LO” setting for
each cooktop burner.
Checking for proper cooktop, bake and broil burner flame is
very important. Natural gas flames do not have yellow tips.
3.
Refer to “Complete Installation” in the “Installation
Instructions” section of this manual to complete this
procedure.
NOTE:
Make sure to save the orifices that have just been
replaced in the conversion.
Moving the Range
WARNING
Tip Over Hazard
A child or adult can tip the range and be killed.
Install anti-tip bracket to floor or wall per installation
instructions.
Slide range back so rear range foot is engaged in the
slot of the anti-tip bracket.
Re-engage anti-tip bracket if range is moved.
Do not operate range without anti-tip bracket installed
and engaged.
Failure to follow these instructions can result in death or
serious burns to children and adults.
When moving range, slide range onto cardboard or hardboard to
avoid damaging the floor covering.
If removing the range is necessary for cleaning or maintenance:
For power supply cord-connected ranges:
1.
Slide range forward.
2.
Turn manual shutoff valve to the closed position.
3.
Unplug the power supply cord.
4.
Disconnect the gas supply tubing.
5.
Complete cleaning or maintenance.
6.
Reconnect the gas supply tubing.
7.
Open the manual shutoff valve in the gas supply line.
8.
Plug in power supply cord.
9.
Slide range back so rear range foot is under anti-tip bracket.
10.
Refer to the “Verify Anti-Tip Bracket Is Installed and Engaged”
section to verify engagement.
11.
Check that range is level.
Summary of Contents for WFG550S0HB
Page 52: ...52 REMARQUES ...
Page 53: ...53 REMARQUES ...
Page 54: ...REMARQUES 54 ...
Page 55: ...REMARQUES 55 ...
