20
As needed cleaning
Laundry detergent and fabric softener residue can build up on the
lint screen. This buildup can cause longer drying times for your
clothes, or cause the dryer to stop before your load is completely
dry. The screen is probably clogged if lint falls off the screen.
Clean the lint screen with a nylon brush every 6 months, or more
frequently, if it becomes clogged due to a residue buildup.
To wash
1.
Roll lint off the screen with your fingers.
2.
Wet both sides of lint screen with hot water.
3.
Wet a nylon brush with hot water and liquid detergent. Scrub
lint screen with the brush to remove residue buildup.
4.
Rinse screen with hot water.
5.
Thoroughly dry lint screen with a clean towel. Replace screen
in dryer.
Cleaning the Dryer Interior
To clean dryer drum
1.
Make a paste with powdered laundry detergent and very
warm water.
2.
Apply paste to a soft cloth.
OR
Apply a liquid, nonflammable household cleaner to the
stained area and rub with a soft cloth until all excess dye and
stains are removed.
3.
Wipe drum thoroughly with a damp cloth.
4.
Tumble a load of clean cloths or towels to dry drum.
NOTE:
Garments that contain unstable dyes, such as denim blue
jeans or brightly colored cotton items, may discolor the dryer
interior. These stains are not harmful to your dryer and will not
stain future loads of clothes. Dry unstable dye items inside out to
avoid dye transfer.
Removing Accumulated Lint
From Inside the Dryer Cabinet
Lint should be removed every 2 years, or more often, depending
on dryer usage. Cleaning should be done by a qualified person.
From the Exhaust Vent
Lint should be removed every 2 years, or more often, depending
on dryer usage.
Vacation and Moving Care
Vacation care
Operate your dryer only when you are at home. If you will be on
vacation or not using your dryer for an extended period of time,
you should:
1.
Unplug dryer or disconnect power.
2.
Close shutoff valve in gas supply line.
3.
Clean lint screen. See “Cleaning the Lint Screen.”
Moving care
1.
Unplug the power supply cord.
2.
Close shutoff valve in gas supply line.
3.
Disconnect gas supply line pipe and remove fittings attached
to dryer pipe.
4.
Cap the open fuel supply line.
5.
Make sure leveling legs are secure in dryer base.
6.
Use masking tape to secure dryer door.
