5
You will need:
n
A location allowing for proper exhaust installation. See
“Venting Requirements.”
n
If using power supply cord, a grounded electrical outlet
located within 2 ft. (610 mm) of either side of dryer. See
“Electrical Requirements.”
n
Floor must support dryer weight of 200 lbs. (90.7 kg). Also
consider weight of companion appliance.
n
Level floor with maximum slope of 1" (25 mm) under entire
dryer. If slope is greater than 1" (25 mm), install Extended
Dryer Feet Kit, Part Number 279810. If not level, clothes
may not tumble properly and automatic sensor cycles may
not operate correctly.
n
For garage installation, place dryer at least 18" (460 mm) above
floor. If using a pedestal, you will need 18" (460 mm) to bottom
of dryer.
All dimensions show recommended spacing allowed, with tested
spacing of 0" (0 mm) clearance on sides and rear. Closet door
ventilation openings show minimum spacing required.
For each arrangement, consider allowing more space for ease
of installation and servicing; spacing for companion appliances
and clearances for walls, doors, and floor moldings. Space
must be large enough to allow door to fully open. Add spacing
on all sides of dryer to reduce noise transfer. If a closet door
or louvered door is installed, top and bottom air openings
in door are required.
1"
(25 mm)
1"
(25 mm)
39" min.
(990 mm)
Custom under counter installation (dryer only):
24 in.
2
(155 cm
2
)
48 in.
2
(310 cm
2
)
1"
(25 mm)
1"
(25 mm)
4"
(102 mm)
3"
(76 mm)
3"
(76 mm)
18" min.
(457 mm)
Closet installation (dryer only):
7"
(178 mm)
4"
(102 mm)
9"
(230 mm)
1"
(25 mm)
1"
(25 mm)
Cabinet installation (dryer only):
1"
(25 mm)
1"
(25 mm)
5
1
/
2
"
(140 mm)
24 in.
2
(155 cm
2
)
48 in.
2
(310 cm
2
)
3"
(76 mm)
3"
(76 mm)
6"
(152 mm)
76"
(1930 mm)
Closet Installation (stacked washer and dryer):
NOTE:
Some models not recommended for undercounter
installation.
Summary of Contents for WGD9250WR - Duet Cranberry - Gas Dryer
Page 14: ...14 Sécurité de la sécheuse ...
Page 15: ...15 ...
