3
Electrical Requirements
Observe all governing codes and ordinances.
Required:
■
A 120 volt, 60 Hz, AC only, 15- or 20-amp electrical supply
with a fuse or circuit breaker.
Recommended:
■
A time-delay fuse or time-delay circuit breaker.
■
A separate circuit serving only this microwave oven.
Settings/Features
Clock
The Clock is a 12-hour (12:00-11:59) clock. Touch CLOCK, enter
time, then touch CLOCK or the Start control.
Timer
With the microwave oven in standby mode, touch the Timer
control, enter time, then touch the Timer control or the Start
control. Cook functions may be entered while the Timer is
counting down. To cancel timer, touch Timer control while the
Timer countdown is active in the display.
Control Lock
Activate to avoid unintended start. Touch and hold the Cancel
control for about 3 seconds until 2 tones sound and padlock icon
appears in the display. Repeat to unlock control.
Vent Fan
High (“SPd2”), low (“SPd1”) and off. Comes on automatically as
cooling fan during any cook function.
Vent Timer (on some models):
Set vent fan to run for exactly 30
minutes, or to run for only 30 minutes more (off after 30 minutes).
The vent fan may be turned off at any time using the Vent Fan
control. Touch and hold number pad “4” for about 3 seconds until
a tone sounds and the vent fan turns on.
Tones
Programming tones and signals. Programming tones may be
turned off, or all tones (including end-of-function signals) may
be turned off. To turn off programming tones, touch and hold
number pad “1” for about 3 seconds, until a confirmation tone
sounds. Repeat to turn back on programming tones. To turn off all
tones, touch and hold number pad “2” for about 3 seconds until a
confirmation tone sounds. Repeat to turn back on all tones.
Demo Mode
Activate to practice using the control without actually turning
on the magnetron. Touch and hold number pad “3” for about 3
seconds until a confirmation tone sounds, and “DEMO” icon lights
up in the display. Repeat to deactivate.
Standby Mode
When no functions are working, oven will switch to standby power
mode and dim the brightness after 5 minutes. Press any button
or open/close the door and the display will return to the normal
brightness.
Turntable
For best cooking results, do not operate the microwave oven
without having the turntable in place.
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
WARNING
This device complies with Part 18 of the FCC Rules.
GROUNDING INSTRUCTIONS
SAVE THESE INSTRUCTIONS
■
For all cord connected appliances:
The microwave oven must be grounded. In the event of
an electrical short circuit, grounding reduces the risk of
electric shock by providing an escape wire for the electric
current. The microwave oven is equipped with a cord
having a grounding wire with a grounding plug. The plug
must be plugged into an outlet that is properly installed
and grounded.
WARNING:
Improper use of the grounding plug can
result in a risk of electric shock. Consult a qualified
electrician or serviceman if the grounding instructions are
not completely understood, or if doubt exists as to whether
the microwave oven is properly grounded.
Do not use an extension cord. If the power supply cord is
too short, have a qualified electrician or serviceman install
an outlet near the microwave oven.
OPERATING YOUR MICROWAVE OVEN
