Remove the levelling feet by unscrewing.
Remove the bottom bracket using an 8 mm socket or spanner.
Remove and replace the pin, using a 10 mm socket to unscrew the
nut and a flat bladed screwdriver to remove the pin. You may
need to push the pin through from the underside to remove fully.
Remove the screw on the base and refit it on the other side.
Remove the blanking plates from the unused side of the fridge/
freezer and refit them in the holes left by the brackets.
Replace the door and brackets in reverse order.
When replacing the feet take care to ensure the larger foot is on
the side without the bracket.
Check the door is aligned horizontally and vertically and that the
seal fits properly all around before tightening the bottom hinge.
Note:
The direction of door opening can be changed. If this
operation is performed by After-sales Service it is not
covered by the warranty.
33502009GB.fm Page 23 Tuesday, October 27, 2009 12:58 PM
21