10
8.
Clean the condenser coils regularly. Coils may need to be cleaned
as often as every other month. This may help save energy.
Open the freezer door and remove the base grille by removing
2 Phillips-head screws and pulling the grille toward you.
Use a vacuum with an extended attachment to clean the
condenser coils when they are dusty or dirty.
Replace the base grille by aligning the ends of the grille with the
leveling assemblies on each side and snapping the grille into
place. Reinstall the screws.
9.
Replace all frozen food.
10.
Plug in freezer or reconnect power.
11.
Set temperature control to desired setting. See “Using the
Control.”
Changing the Light Bulb
NOTE:
Not all appliance bulbs will fit your freezer. Be sure to replace
the bulb with an appliance bulb of the same size, shape, and wattage.
1.
Unplug freezer or disconnect power.
2.
Remove the light shield by squeezing the lens from the sides,
pushing back and pulling down.
3.
Replace bulb with a 40-watt maximum appliance bulb or an LED
NOTE:
Some LED replacement light bulbs are not recommended
4.
Replace the light shield.
5.
Plug in freezer or reconnect power.
Power Interruptions
If the power will be out for 24 hours or less, keep the door closed to help
food stay cold and frozen.
If the power will be out for more than 24 hours, do one of the following:
Remove all frozen food and store it in a frozen food locker.
If a food locker is not available, consume or can perishable food at
once.
REMEMBER:
A full freezer stays cold longer than a partially filled one.
A freezer full of meat stays cold longer than a freezer full of baked
goods. If you see that food contains ice crystals, it may be refrozen,
although the quality and flavor may be affected. If the condition of the
food is poor, dispose of it.
Moving Care
When you are moving your freezer to a new home, follow these steps to
prepare it for the move.
1.
Remove all frozen food.
2.
Unplug the freezer.
3.
Take out all removable parts, wrap them well, and tape them
together so they don’t shift and rattle during the move.
4.
Clean the freezer thoroughly.
5.
Tape the freezer shut and tape the electrical cord to the cabinet.
When you get to your new home, refer to the “Installing Your Freezer”
and “Operating Your Freezer” sections for information on installation
and setting the controls.
rated for wet/damp locations.
for wet/damp environments. Refrigerator fresh food and freezer
compartments are considered wet/damp environments. Read
and follow all instructions on the LED packaging when replacing
the faactory installed LED bulb. A replacement LED bulb can be
purchased from an authorized dealer.
