Page 13
6.
Oven burner:
Use 1/2" combination wrench to turn the
orifice hood down snug onto pin (approximately 2 to 2-1/2
turns).
DO NOT OVERTIGHTEN.
The burner flame cannot be
properly adjusted if this conversion is not made.
orifice hood
Gas conversions
cont.
Natural gas conversion
1.
Check that main gas supply line has been shut off and
the power supply cord is disconnected.
2.
Remove
burner grates.
cap
washer
Nat. gas
L.P. gas
pressure
regulator
L.P.
pressure
regulator
Natural
plastic
cover
plastic
cover
DO NOT REMOVE THE PRESSURE REGULATOR.
hood
pin
L.P. gas
decrease
gas
decrease
flame size
Natural gas
increase gas
increase
flame size
pre-set at factory
for Natural gas
7.
Complete installation sections D through E, Pages 9-11.
Check for proper flame. The small inner cone should have a
very distinct blue flame 1/4" to 1/2" long. The outer cone is
not as distinct as the inner cone. L.P. gas flames have a
slightly yellow tip. If the flame is noisy or blowing, it is
getting too much air. If the flame is soft and lazy, it is not
getting enough air.
3.
Open broiler drawer to locate pressure regulator.
Pressure regulator:
Remove plastic cover. Turn cap marked
“L.P.” on front of pressure regulator counterclockwise with a
wrench to remove.
Do Not disturb or remove the spring
beneath the cap.
Turn the cap over and reinstall cap on
regulator so that the letter “N” is visible. Replace plastic
cover over cap.
4.
Cooktop burners:
Lift up cooktop maintop until it is
held in place by support rods. Remove shipping screws from
each burner. Remove burners.
shipping
screw
burner
air shutter
5.
Locate Natural gas orifice spuds in literature
package. All Natural gas orifice spuds are stamped with “54”.
Remove L.P. gas orifice spuds using a 3/8" combination
wrench. Install Natural gas orifice spuds to replace the L.P.
gas orifice spuds.
Place L.P. gas orifice spuds in plastic parts bag for future use
and keep with literature package. Reinstall burners. Lower
maintop to operating position. Reinstall burner grates.
orifice spuds
NAT
L.P.
L.R.
L.F.
R.F.
R.R.
Remove and
replace orifice
spuds.
gas
manifold
notches
