9
Install Visor
1. Open visor, and slide its mounting tray – with the mounting
tray edges facing down – into the slot between the microwave
oven bottom and the bottom plate, as shown.
2. Secure visor by installing two 17 mm shoulder screws through
the bottom plate into the visor mounting tray.
Install Charcoal Filter Kit
(for recirculation venting only)
The charcoal filter kit should be used. See “Assistance” section
for information on ordering.
To Install Charcoal Filter:
1. Cover the inside of the grease filter with the charcoal filter.
2. Insert wire rods to hold charcoal filter in place.
3. Install grease filter. See “Install Grease Filter” section.
Install Grease Filter
1. Place bracket end of the grease filter into one side of the
bottom plate opening, push toward the bracket end, and
swing up the tabbed end of the grease filter.
2. Push the tabbed end of the grease filter up until the tabs are
above the opening, then release the tension.
A. Visor
B. Visor mounting tray
C. Bottom plate
A. Visor
B. 17 mm shoulder
screws
C. Bottom plate
A. Charcoal filter
B. Grease filter
B
C
A
A B C
A
B
A. Charcoal filter
B. Grease filter
C. Wire rods
A. Grease filter
B. Tabs
C. Bracket
A
B
C
A
B
C
Summary of Contents for YUMV4084BS
Page 23: ...23 Notes ...
