June 2021 W-SQ-Pro 15 and W-SQ-Pro 18
3
1 INTRODUCTION
1.1
GENERAL
This installation manual applies to the installation of
Whisper gensets in mobile/land applications. This manual
is valid for the following models:
Generator Description
W-SQ Pro 15 230- 400 V / 50 Hz
1phase / 3phase / Stage-V, 1500rpm, Mobile
W-SQ-Pro 18 230- 400V / 50 Hz,
1phase / 3phase / Stage-V, 1500rpm, Mobile
For other models see our website: www.whisperpower.com
WARNING!
A warning symbol draws attention to
special warnings, instructions or
procedures which, if not strictly observed,
may result in damage or destruction of
equipment, severe personal injury or loss
of life.
DANGER
This danger symbol refers to electric
danger and draws attention to special
warnings, instructions or procedures
which, if not strictly observed, may result
in electrical shock which will result in
severe personal injury or loss of life.
WARNING!
Before working (installation) on the system
read the section safety instructions in the
User Manual.
1.2
GENERATING SETS FOR MOBILE/LAND
APPLICATIONS
On mobile/land applications the engine of the W-SQ- Pro
15/11 and W-SQ- Pro 18/15.5 are cooled by a radiator with
an electric (230V or 3x400V) driven fan. Note that the
alternator of these generator sets is cooled by air. The
radiator of the engine can be fitted below, on top or in the
side of the vehicle.
The exhaust is of the dry type and includes a stainless
flexible bellow and high-quality mufflers.
Never use rubber exhaust hose, neither
fibre glass nor plastic exhaust parts in a
dry exhaust system as applied on
mobile/land applications.
Figure 1: Typical vehicle application radiator side mounted
