1.
Locate the desired installation location. U
sing a stud finder
, locate the ceiling
joists on either side of the center point. Cut and frame an opening in the ceiling
measuring 14.5” x 36”. Make sure the fr
aming is sufficien
t to support the weight of
the cooling unit. Use only the mounting locations provided. These locations ensure
that the installer will not drill into any critical components within the system.
2.
Determine which orientation the evaporator unit will be installed in (inside the
cellar or with attic access). Mounting options are listed below:
Minimum Tools Needed:
Fully exposed mounting option
Flush mount option
Choose a mounting
option suitable
for the installation
location.
Partially recessed mounting option
Hammer
Saw
#2 Phillips-head
screwdriver
SELECTING MOUNTING OPTION
T-square
1
2
3
4
12.65”
12.65”
5.75”
6.9”
6.9”
5.75”
Page 12
08/04/21
