5. Place the display on the wall mount bracket as shown, attaching the back of the display panel to the magnets on the
mounting bracket. Make sure that the alignment tab on the back of the display panel sits in the notch on the bottom
of the bracket.
Wall mount
bracket
WALL MOUNT BRACKET INSTALLATION, CONTINUED
Display
4. Connect the end of the display cable labeled “
DISPLAY
” to the JST connector on the back of the display.
DISPLA
Y
JST connector
NOTE:
Before you continue to Step 4, locate the area where the display will be mounted. You may route the display wire
into the housing one of three ways: either through the wall or through one of the holes on the top or bottom edges of
the wall mount bracket. If you’d like to route the display cable through one of these holes, place a rubber grommet into
the hole and then route the display cable through the grommet and into the wall mount bracket.
Page 23
08/04/21
