SC 060815
Page 16 | 1-800-343-9463
LIQUID MEASURING THERMOSTAT SYSTEM
The WhisperKOOL Series cooling units come equipped with a liquid temperature-measuring thermostat. This system
incorporates the following advantages:
Self-Calibrating Bottle Probe
The bottle probe contains a sensor chip, which communicates back and forth with the thermostat. This results in a consistent
temperature setting and accuracy.
1. Wine temperature is kept in a very precise, controlled environment. This assures a consistent temperature.
2. By measuring the liquid temperature rather than air, the unit will operate 75–80% of the time.
Liquid Temperature Measuring Thermostat
To assure a consistent temperature, place bottle probe approximately 3 feet away from the air output and not in the flow
of the air.
To Use the Thermostat:
1. Locate an empty wine bottle.
2. Fill ¾ full with room temperature tap water.
3. Place bottle probe securely into bottle making
4. Place bottle with probe level and to the side of the unit in your wine cellar.
It is recommended that the bottle be placed in a central location of your wine
cellar. Avoid pulling too much on the probe cord. It may become disconnected
resulting in non-operation of the unit.
Note: The thermostat can be set between 50–70°F.
Remember: The WhisperKOOL unit operates based on the temperature of the
water. Do not be misled by thermostats reading air temperature. The air
temperature in the cellar will be cooler than the liquid temperature of
the wine while it is reaching optimum balanced temperature.
