46
WhitakerAudio
– Install connecting wires from the PWB pads to the tube socket pins. Solder in place.
Materials for these steps can be found in the “Tube Socket Hookup” package. Note that
the heater connections are made separately. The recommended procedure for installing the
connecting wires is as follows:
1) Feed a bare wire from the component side through the pad and into the socket
soldering tab.
2) Crimp in place (see Figure 5.2
b
).
3) From the component side, pull the wire tight and solder in place.
4) Trim the excess lead length.
5) Solder the socket tab.
Table 5.1 shows the pins that should be connected to the PWB.
(
a
)
(
b
)
(
c
)
(
d
)
Figure 5.2
Installation of sockets on the PWB: (
a
) mount the socket on the standoffs, (
b
) insert
connecting wires from the PWB to the socket, (
c
) board-to-socket connections completed, (
d
)
finished job with heater wires installed.
Summary of Contents for AM/FM Stereo Tuner 2012
