STEP 4: Press the Steam Switch (R) ON, wait for several
seconds to let the water accumulated in the Steam duct
(D) run out for cleaning purpose. Then press down the
Steam Switch (R) OFF to terminate the cleaning
process.
STEP 5: Rotate Steam duct (D) outwards closing to the
right corner. Then move the container to the Steam duct
(D) and locate this Steam duct (D) in the middle of this
container, and immerse the bottom end of the duct into
the fresh milk. (Fig.4).
STEP 6: Press down the Steam Switch (R) ON to begin the frothing.
[ATTENTION: When milk foam starts to create, operator should lower down somewhat the
container to attain the favorable frothing effects and avoid any foam likely from overflowing
out of the mouth of the container]. After achieving the expected frothing, press down the
Steam Switch (T) OFF to turn off the steam.
STEP 7: Rotate the Steam duct (D) inwards, and repeat the above procedure 4 for cleaning
purpose.
STEP 8: Press Power Button (N) to disconnect the power, empty the Anti drip tray.
HOW TO OPERATE TO HOT WATER
STEP 1: Repeat the above procedure 1, 2
STEP 2: Put a cup under the steam duct.
STEP 3: Press down the steam Switch (R) ON, and press down Brewing Button (P), the
pump will work. Then the steam will come our from the steam duct into the cup at first, then
the hot water will come from the steam duct into cup.
STEP 4: The hot water will come out until the water in water tank is out if the steam switch
and the Brewing Button are in ON position. if you want terminate the hot water, just put
either the Steam Switch or the Brewing Button in OFF position.
ATTENTION: During the operation, the temperature of steam duct and base of boiler is very
high; don’t touch them with your hand.
To get optimal result, before every usage, please fit the empty funnel bracket into the unit
properly, and use only water in the first cycle, then throw away the water in the cup.
14
EX_825_ notice 6/11/06 21:01 Page 14
