35362-3-1015
Page 46
REMOTE CONTROL OPERATION INSTRUCTIONS
Initializing the System for the First Time
1. Install the three AAA type batteries in the Transmitter battery
bay located on the base of the Transmitter (back side).
See
Figure 58.
2. Power the receiver
3. With the ON/OFF rocker switch turned ON, press red button
on the module.
7KH5HFHLYHUZLOO³EHHS´WKUHHWLPHVWRLQGLFDWHWKDWLWLV
ready to synchronize with a Transmitter.
5. With the batteries already installed in the Transmitter, push
WKH³21´EXWWRQ7KH5HFHLYHUZLOO³EHHS´WRLQGLFDWHWKH
Transmitter’s command is accepted and set to the particular
code of that Transmitter.
6. The system is now initialized.
Figure 58
Temperature Indication Display
:LWKWKHV\VWHPLQWKH³2))´SRVLWLRQSU(50267$7
key and the MODE key at the same time.
/RRNDWWKH/&'VFUHHQRQWKH7UDQVPLWWHUWRYHULI\WKDWD&RU
)LVYLVLEOHWRWKHULJKWRIWKH5RRP7HPSHUDWXUHGLVSOD\
See
Figures 59a and 59b.
Figure 59a - Degrees Celsius
Figure 59b - Degrees Fahrenheit
Turn the Appliance ON and OFF
1. With the system OFF, press the ON/OFF key on the Trans-
mitter. The Transmitter LCD display will show some other
active Icons on the screen. At the same time the Receiver
will activate the appliance.
$³EHHS´IURPWKH5HFHLYHUZLOOFRQ¿UPUHFHSWLRQRIWKHFRP
-
mand.
3. TURN
OFF
THE
APPLIANCE
4. With the system ON , press the ON/OFF Key on the Trans-
mitter. The Transmitter LCD display will show the room
temperature.
See Figure 60.
At the same time the Receiver
will turn off the appliance.
$³EHHS´IURPWKH5HFHLYHUFRQ¿UPVUHFHSWLRQRIWKHFRP
-
mand.
Figure 60
