33740-7-0515
Page 15
INSTALLATION
Framing and Finishing
CAUTION
MEASURE FIREPLACE DIMENSIONS AND VERIFY FRAMING
METHODS, AND WALL COVERING DETAILS BEFORE
FRAMING CONSTRUCTION BEGINS.
1. Choose unit location.
2. Frame in fireplace with a header across the top.
NOTE:
Fireplace framing can be built before or after the fireplace
is set in place. Framing should be positioned to accommodate
wall covering and fireplace facing material. The fireplace framing
should be constructed of 2 x 4 lumber. The framing headers
may rest on the fireplace standoffs. Refer to
Figures 15 and
16
for minimum framing dimensions.
NOTE:
When installing this unit against exterior wall, insulate to
applicable insulation codes.
3. Remove two screws which are accessed through the clearance
holes in the rear heat shield.
See Figure 17
. Hand bend the
rear stand-off as shown in
Figure 18 and Figure 19.
Replace
the two screws previously removed to secure stand-off to unit.
3. Attach fireplace to frame using nailing flange. Preset depth to
suit facing material (adjustable to 1/2 inch or 5/8 inch depths).
See Figures 20 to 22.
*Adjust accordingly if chase is finished with drywall or other material.
Figure 15
Figure 16
Figure 17
