Page 11
15628-0-0903
7. Refer to Figure 8, attach casting support to rear cover with (4)
10 x 1/2" screws. The rear cover has (4) keyholes for
attachment to the casting sides. Stand the casting sides on the
floor with the (2) bolts attached half-way into the edges of the
rear cover positioned at the rear. The large diameter holes in
the keyholes of the rear cover will be toward the floor.
Working with one casting side at a time, place the large
diameter holes in the keyholes over and behind both of the
bolts at the same time. Push downward on the rear cover to
lock the keyholes into position behind the bolts. Finish
tightening both bolts to secure rear cover to casting side.
Repeat this procedure to secure rear cover to the second
casting side.
Figure 8
8. Position the completed portion of the casting in the
approximate location for installation as the completed
assembly will be heavy.
9. Refer to Figure 9, remove protective packing foam from
casting front and window. Remove the (1) 3/4" bolt and (1)
1/4" washer from top of window. Remove (1) 3/8" bolt and
1 - 5/8" x 3/4" retaining tab from bottom of window. Remove
the window from casting front. Remove the protective sheet
of foam from the casting front.
Place the window into the casting front. Attach the top of the
window to the casting front with (1) 1/4" washer and (1) 3/4"
bolt. Place the 1 -5/8" x 3/4" retaining tab into the locator
notch on the bottom of the casting front. Attach the bottom
of the window to the casting front by inserting (1) 3/8" bolt
through retaining tab and into locator notch.
10. Refer to Figure 9, attach the (4) 1-1/4" x 1/2" retaining tabs
to the casting front with (4) 3/8" bolts. The retaining tabs
should be positioned downward.
Figure 9