DEHUMIDIFIERS
DEHUMIDIFIERS
-5-
6. LCD monitor
When the unit is running, the LCD monitor will go dark if no buttons are pushed. Push
any button once to light monitor.
7. LCD display function
（
1
）
Show“Power On”when the machine has already connected but not started.
p o w e r
o n
Use to confirm a selection.
4. Select/OK Button
OK
These buttons are used for adjusting humidity or timer settings.
5. UP Botton Down Botton
Humidity Setting: Adjust the humidity setpoint
Timer Setting: Start Time Setup/Stop Time Setup/Cycle Time Setup
Temperature Scale Switch: Choose between Celsius and Fahrenheit readings
Return: Return to the main menu
NOTE: See Section 8 for more detailed programming instructions.
Four selections are available:
n
U n
i
t
O
（
2
）
Show“Unit On”when the machine is in working status (This display will change
to next screen in 2 seconds).
（
3
）
The LCD interface shows two lines of data. The first line displays the room
temperature and humidity. On the second line, Job T(working time) and Humidity Setpoint
are displayed on an alternating basis.
I
n
l
e
t
3 2
℃
7 6
%
The contents of the second line alternate every 10 sec.
※
Operating instructions
※
OK
M
P
Menu
Up Button
Down Button
LCD Monitor
On/Off
Select/OK
Drain Pump
※
Control Panel Operation
1. ON/Off Button
Press this button, and the machine will start running. Press this key again and the
machine will stop running. The display will show room humidity levels except while you’re
pressing another button. NOTE: When unit is turned off, the fan will run for 1 minute prior
to shutting off.
“ In addition the condensate pump will pump for approximately 14
seconds to drain the pump reservoir after unit is powered off.”
2. Pump Button
P
For extended storage or movement of the machine, press the“Pump”bottom to
remove water from the integral pump’s reservoir.
3. Menu Button
M
Pressing the Menu (M) button, gives you the options to select between two different
control modes as well as adjust the temperature measurement units. Continue pressing
the M button until you get to your desired selection. Press the Select (OK) key to confirm
that selection and move to a submenu.
After you’ve completed your task, select“R”,then press the“select/ok”button to
move back to previous menu, or wait 10 sec to automatically return to the main screen.
-4-
