WHITEHALL MANUFACTURING
• P.O. BOX 3527 • City of Industry, CA 91744-0527 U.S.A
Phone (800) 782-7706 • (626) 968-6681 • Fax (626) 855-4862 • Web: www.whitehallmfg.com
Instructions for Operation and Care of Little Therm Compact Thermalator
•
•
•
•
•
•
Do not use bleach or iodine based products to clean
the tank as such products can quickly corrode the
stainless steel tank resulting in pin holes and leaking
water.
•
Do not touch cord or plug if you are wet, standing in
water or on a wet surface.
•
Constant supervision is necessary when the unit is
used with children, invalids, or any one who cannot
safely operate the unit.
WARNING
Do not use the unit outdoors.
•
Do not reach into water to get the thermal packs. Use
the blue or white tabs or tongs.
Do not place the Thermal Pack on bare skin. Always
place the Thermal Pack in a terry cover.
•
Refer service and electrical problems to qualified
personnel and/or Whitehall Manufacturing only.
•
Do not use if the unit, cord, or plug has been damaged.
Return unit to Whitehall Manufacturing or a qualified
service center.
•
Do not use an electrical extension cord. Plug unit
directly into a properly grounded receptacle. If there is
any question on the grounding of the receptacle, call
an electrician.
DANGER
•
•
•
4
•
The instructions below are indicated by specific symbols. An
understanding of these symbols, their companion text and
the specific instructions and captions must be understood
prior to operation of the equipment and patient treatment.
All internal parts capable of transmitting electric current
are grounded. Therefore, the electrical outlet to which
the unit is attached must be properly grounded.
Grounding reliability can only be achieved when the
equipment is connected to an equivalent receptacle
marked "Hospital Only" or "Hospital Grade". If there is
any question as to the electrical protection, a qualified
electrician should be consulted.
The table or cart must be level for proper and safe use.
Little Therm Compact Splint Pans are intended for use
only where the person utilizing the treatment is under
the supervision of trained personnel.
DO NOT operate the unit dry - always make sure to fill
with water before plugging in unit.
Treatment temperature must be monitored closely and,
of course, a patient's medical history must be reviewed,
as with any heat modality, for heat sensitivity and
circulatory problems.
CAUTION
!
!
CAUTION- Ignoring the following could cause
injury or equipment damage.
WARNING- These are safety infractions that
could result in serious injury.
DANGER- These are possible safety infractions if this
equipment is used where flammable anesthetics are
present.
Always disconnect the line cord plug from the
receptacle before working on any unit.
Replace fuse as marked 10A/250VAC fast acting glass
tube type.
•
!
Do not operate any thermalator where flammable
anesthetics are present.
