30
Prizm™ 6T
#2.
Using a sturdy
digging tool, preferably a
trowel or
knife, cut a
horseshoe-
shaped size
plug around
the pin-
pointed
target. Leave an uncut
hinge area to keep the
grass in place.
#1.
After locating
a good
target (metal),
pinpoint the
center. If your
instrument has
depth reading,
take note of
the depth.
Practice on surface
metals with the loop held
several inches above target.
#4.
Use your digging
tool to pry the turf flap up
and hinge it over. Your
pinpointed target
now rests
down-side
up.
#6.
A pinpointing probe
can be used to speed the
process of finding the
target in the
flap or in
the hole.
#5.
Check for the target
visually, and with your
detector, to see if the
target is in the flap
or remains
in the
hole.
#3.
Cut through the
turf, being careful to
cut around the
target and not
damage it.
#9.
Replace the turf flap
and step on it firmly.
Once completed very
little indication
of digging
should be
seen.
#8.
After recovering the
target, the dirt can then
easily be replaced with a
minimum of spreading.
#7.
If additional dirt
needs to be removed from
the hole,place it on a drop
cloth.
It is very important for the future of metal detecting that you use care
in digging - - -
The following
“
Hinged Door Method
”
of digging is widely recom-
mended to minimize damage to lawns. Careful recovery in
multiple-use well-groomed areas is the responsibility of all metal-
detector users.
Target Recovery
•
Check with your Dealer, Area Club, Local Police, or Parks & Recreations Dept.
•
Some areas may have rules on the size and type of digging tools allowed.
•
Be aware of the rules, and respect the laws and restrictions in your area.
•
Unsightly holes are dangerous to people and livestock, and detrimental
to the continued use of detectors.
Summary of Contents for Prizm 6T
Page 2: ...2 Prizm 6T ...
Page 8: ...8 Prizm 6T Prizm 6T Search Display ...
Page 31: ...31 Prizm 6T NOTES ...
