White’s Electronics Vision, Manual

  Vision Assembly Guide 

ASSEMBLY INSTRUCTIONS -

.

  Remove all parts from shipping carton.   Check the assembly page to make 

sure all parts are present. 

. 

 Use the provided rubber washers between clevis/lower rod and loop ears. 

Use only nonmetallic washers, fiber bolt, and thumbnut to secure loop/search coil 
to clevis/lower rod. 

.

  Unlock “S” rod camlock and insert clevis/lower rod into curved “S” rod 

so that stainless steel spring clip buttons line up and lock into one of the 
adjustment holes in the curved “S” rod.  Turn camlock to secure. The second 
or third adjustment holes are suitable for average size adults.  Individuals 6’ 
or taller should use the fully extended position.  Individuals well over 6’ tall 
should purchase the optional Tall Man Fiber Lower Rod #500-0242-3 and/or             
#500-0240-1 Tall Man Aluminum “S” Rod. 

. 

 Unravel loop cable and wind the cable around the clevis and rod assembly, 

first revolution over the top of the rod. Wind cable all the way to the top of the 
curved “S” rod, about five revolutions.  Use the black cable retainers, one near 
the loop, and one near the top of the curved “S” rod, to hold the loop cable in 
place. 

5. 

Unlock control box rod cam-lock and insert curved “S” rod so that stainless 

steel spring clip buttons line up and lock into the rod on top of the control box. 
The “S” rod is designed to curve up toward the display. However, those who 
prefer to sweep the loop close to their feet may desire to assemble the “S” rod 
to curve down toward the ground. Turn cam-lock to secure. Plug loop connector 
into control box, screw lock ring to secure. 

6. 

 Grip the instrument by the handle, with your arm in the elbow cup with strap 

secure, and sweep the loop/search coil over the floor. If the instrument fit feels 
uncomfortable, adjust the elbow cup by removing and repositioning the bolt/
thumbnut and installing in one of the optional positions. If necessary, readjust 
clevis/lower rod length with the spring clip buttons and cam-lock so that the 
search coil can be held near the floor without requiring stooping over.