Vision Assembly Guide 5
7.
Remove the protective paper from the two black elbow cup foam pads.
Carefully align pads on the inside of the elbow cup, one on each side of the
center rod, and press firmly into place.
8.
Adjust the elbow cup strap so that it is loose enough for you to slide your arm
in and out without loosening each time you want to set the detector down. The
elbow cup strap provides extra leverage and control. However, some prefer not
to use it.
9.
Install battery as described in the next section, decal facing down, single
larger plastic tab and steel contacts facing toward inside of battery compartment.
0.
It should be noted at this point that the Vision may not work as expected
indoors due to the high degree of metals used in modern construction. It is best
to tune and practice (outdoors) to ensure stable, predictable results.
.
Your Vision is designed with an automatic turn OFF if the trigger on the grip
(or another control) “is not used” for a period of 30 minutes. This protects the
battery from damage (absolute discharge) in case of an accidental turn on during
travel or storage. The Vision will make a specific deep tone musical melody
upon automatic turn off. To restart, simply press ON and squeeze and release
the trigger on the grip to resume searching. The Vision returns to pre-turn-off
settings.
Batteries
The Vision is provided with two battery packs. A rechargeable Nickel Metal
Hydride (NiMH) battery (Orange Decal) will require an initial 3-4 hour battery
charge.
Orange Decal
