6
Step 3: Align the two points between the main unit and the end cover, then turn the
knob clockwise to lock.
Fig.7 Lock the end cover
CHARGING THE BATTERY:
The ‘power’ and ‘charging’ LED lights will both be illuminated if the charger is
connected to the power supply.
The ‘charging’ LED will change from green to red if a battery is inserted into
the charger. This means that the battery is charging.
The LED will change from red to green after 3 hours, indicating that the
charging process is completed.
The battery should not be used immediately after charging. It should be
allowed to cool down first. The charged battery can be used at full load for no
less than 8 minutes.
The battery should be charged approximately every 15 days if the saw is not
going to be used on a regular basis.
Normally the battery can be charged and discharged approximately 150 times. After
the charger is connected to the power supply, the LED turns green. It means that the
capacity is full. Otherwise the capacity is not full. These batteries should be charged
again or replaced.
Note: Explosion hazard if batteries are exposed to flames. Properly dispose of used
batteries.