4
Figure 2
Maintenance
Always disconnect the stove from the electricity supply socket and allow the
stove to cool before commencing any maintenance.
Lamp Replacement
The lamps fitted to this stove are long life types but, due to the indeterminate life
span and ease of replacement, they are specifically excluded from the guarantee
Open the stove door.
Lift out the coals and the fuel support and place on a sheet of paper. See figure 2.
Remove the lamp by carefully rotating it anti-clockwise until it comes out of the
holder.
Replace with a
60W clear Edison screw
lamp. Do not use opaque or coloured lamps.
Refit the fuel support and coals.
Cleaning
The stove surfaces and door glass should only need occasional wiping with a soft dry cloth. Do not use
polishes or abrasive cleaners.
Use a vacuum cleaner with a soft brush attachment occasionally to remove any dust or fluff from the fan air
outlet grille underneath the stove.
Fault Finding
No light or low light level from the flame effect but fan and heater element are working:
Most likely due
to a lamp failure. Check and change any defective lamp as described above. If the lamps are not defective
and are correctly screwed into the holders but the fault persists get expert advice.
No heat but the fan and flame effect light are working:
The thermal safety cut-out may have operated.
The cut-out will operate if the fan air outlet is obstructed. Switch the stove off, disconnect the mains plug
from the socket and allow the stove to cool. Look for and remove any obstruction if possible. If an
obstruction can not be removed, or if the cut-out operates for some other reason, leave the stove switched
off and get expert advice.
No heat or flame effect light and the fan is not working:
Check that the fuse in the stove plug is
functional. If so, check that the wall socket is satisfactory by plugging in another appliance which you know
is working. If there is no problem with the fuse or socket, disconnect the stove and get expert advice.
Disposal
At the end of its serviceable life, dispose of the appliance thoughtfully and safely and in accordance with any
national or local regulations. We suggest that you cut the mains cable from the stove to prevent any future
unsafe use of the appliance.
Wickes Helpline
If you require any further assistance please call the
Wickes Helpline
on
0161 366 4224
To help us quickly help you, please try to have the following information available before you contact us.
•
Your Post Code
•
Type of Fire
•
Model / Name
•
Serial Number
•
The fault, problem or request