widinovations Confidential
©
30
6.
Maintenance
An adequate maintenance routine will keep your widlaminator L300 in good working condition and prolong
its lifetime
Carefully read the indications below to ensure adequate maintenance.
Avoid direct contact between sharp objects and the rolls, to prevent damage to the latter.
It is forbidden to cut the material over the rolls. Use the adequate guides for the correct cutting position.
During idle periods place the yellow support hooks in their position to prevent deformation of the rolls.
Weekly, empty the deposit on the compressor to purge it of water accumulations and preventing its
deterioration.
Weekly, empty the deposit on the humidity filter.
Monthly, verify and supply the lubrication system with oil.
6.1.
Humidity filter
After a significant duration of time the humidity filter will accumulate water in its cup. To empty it, push the
cup upwards to release a discharge of air and water from the orifice on the bottom of the cup. Place a rag or paper
below it to avoid wetting the floor.
6.2.
Cleaning and maintaining the rolls
Regularly clean the silicone rolls, with cold water or ethyl alcohol.
Do not clean the rolls unless they are at room temperature.
Do not scrub the rolls with scrubbers, sandpaper or any other abrasive product.
