widinovations Confidential
©
31
7.
Troubleshooting
This chapter should assist maintenance personnel with the identification and resolution of operational faults
based on error messages and symptoms.
ATTENTION
Repairing faults incorrectly can cause serious injury or damage. For this reason, this work may only be carried out
by authorized, trained personnel who are familiar with how to operate the machine and in strict observance of all
safety instructions.
INFO
Movements and functions may only be performed when there are no errors and all devices are ready for
operation. This state is prerequisite for starting the widlaminator L300.
7.1.
Errors, cause and resolution
Problem
Possible Cause
Resolution
The machine turns of but the
The emergency buttons are
pressed;
Verify both emergency buttons and rotate them
clockwise to release;
up.
Nonexistent heating element;
;
The support hooks are in position;
Rotate the control handle upwards, remove the
support hooks and lower the roll again;
.
Lack of compressed air;
- Verify the compressor is on and has adequate
pressure (> 0.4Mpa);
- Verify the air tube connections;
- Verify the pressure in the humidity filter display;
The equipment stops during
mode.
Hand protection sensor activated;
Verify that no objects are interfering with the
protection sensor, activating it;
Hand protection sensor activated;
sensor;
For other faults, get in contact with the widinovations, lda, support.
