Kunststoffschweißtechnik
Operating
and
indicating elements
Chapter 4
07.02.13
Working Instructions WIDOS 25000 mobile
Page 22 of 116
Especially take care during assembly / disassembly that you do not damage
the main cylinders.
Caution while you detach the reducer inserts out of the clamping tool; the
reducer inserts may swing.
Mounting of the front reducer inserts.
Open the front clamping rings.
Bring the reducer insert below the open
clamping ring.
Carefully shut the clamping rings.
Move the reducer insert by a crane in a
way that it rests according to the radius
of the clamping ring and the lateral lugs
rest against the clamping ring from the
outside.
Fix the reducer insert in the clamping
ring by two bolts for reducer insert. Six
drill holes are available for fixing.
Mounting of the rear reducer inserts.
Open both clamping tools.
Bring the rear reducer insert into the
machine.
Move the reducer insert by a crane in
a way that it rests according to the
radius of the clamping ring and the
lateral lugs rest against the clamping
ring from the outside.
Fix the reducer insert and the
clamping ring by two bolts for reducer
insert within two of the six drill holes.
Always insert the bolt for reducer insert into the drill hole up to limit stop; afterwards it is
maintained by the elastic pressure piece.
Hinge assembling aid here (ring bolt 1)
Front reducer insert (contained in the
second drill hole)
Right clamping ring, shut
Bolt for reducer insert
Elastic pressure piece
Hinge assembling aid here (ring bolt 1)
Rear reducer insert (contained in third
drill hole)
Plug-in bolt for reducer insert here
