Kunststoffschweißtechnik
Operating
and
indicating elements
Chapter 4
07.02.13
Working Instructions WIDOS 25000 mobile
Page 27 of 116
4.5. Pipe
cutter
The cutter drives between both pipe ends in order to cut them and is fixed there.
Then, you must swing in the cutter into the machine and fix this position.
Drive the pipes towards the cutter thus far that the blades are appr. 3-5 cm within the pipes.
As soon as the pipe cutter is rotating, it drives appr. 1 mm per rotation to the outside, in cutting
direction.
The head of the cutter features cutting blades on both sides; they cut the pipe from inside to
outside.
You may also adjust the blades to the
pipe inner diameter by the portable
screwdriver.
Suggestion: Drive the blades towards the
pipe inner diameter at a short distance
and start cutting by the remote control
afterwards.
While setting the blades onto the pipe
inner diameter, make sure that the blade
holder is within the green marking.
Never exceed the red marking
!
Make sure that nobody can start the cutter by the remote control while you shift
the blades back and forth by the portable screwdriver!
Apply portable screwdriver here
Blade (different version)
Blade
Driving range, colored
