Kunststoffschweißtechnik
Operating
and
indicating elements
Chapter 4
07.02.13
Working Instructions WIDOS 25000 mobile
Page 32 of 116
4.10. Stub end holder (optional)
You may use the stub end holder e.g. to weld a flange or cap to a pipe.
Drive both double clamping tools outwards.
Open e.g. the right double clamping tool.
Lift the stub end holder at the ring bolt.
Put the stub end holder into the right inner double clamping
ring by a crane, with the flange showing inwards.
Caution, danger of tilting!
Hold the stub end
holder by the crane thus long until the holder is
within the shut clamping ring and clamped by the
clamping ring upper part.
In case the rear side of the flange rests against the
rear clamping ring, you may shut the clamping tool
carefully and clamp the inner clamping ring
afterwards.
In order to adjust the limit stop, release the
hexagon socket screw.
Shift the limit stop onto the requested dimension
on the scale and fix the hexagon socket screw
again.
Ring bolt
Arrester
Scale
Clamping claw
(10 pieces)
Read dimension here
