Kunststoffschweißtechnik
WIDOS
Einsteinstr. 5
Phone +49 (0) 71 52 99 39 - 0
W. Dommer Söhne GmbH D-71254 Ditzingen-Heimerdingen
Fax
+49 (0) 71 52 99 39 - 40
Website: http://www.widos.de
Email: info@widos.de
22.11.2005
Working Instructions WIDOS 4900 CNC 3.0 (110 V)
Page 21 of 76
5. Starting and operating
The instructions of this chapter are supposed to initiate in the operation of the machine and
lead during the appropriate starting of the machine.
This includes
•
the safe operation of the machine
•
using all the possible options of the machine
•
economic operation of the machine
5.1. Safety indications
•
The machine should only be operated by initiated and authorized persons.
For the qualification, a plastic welding exam can be taken according to DVS and DVGW.
•
In situations of danger for persons and the machine, the EMERGENCY-Stop push button or
the main switch have to be activated immediately.
•
After completion of the welding work and during breaks, the machine has to be switched
off. Further be sure that no unauthorized person has access.
•
According to VDE 0100, the use on construction sites is only allowed with a power
distributor with a FI-safety switch.
Check the oil level of the hydraulic system before each starting of the control
unit in order to avoid damages on the pump.
If necessary, add hydraulic oil of the quality HLPD 32.
The heating element surfaces should be clean, especially non greasy,
therefore they need to be cleaned shortly before each welding or in case of
dirtiness by means of a
fibre-free paper
and
cleaning agent (e.g. technical
pure alcool or cleaning tissues which are available at the WIDOS company).
The anti-adhesive coating of the heating element must remain undamaged in
the working area.
Take care that all hydraulic and electric connections are connected.
Never
lift or transport the basic machine
at path measuring system!
•
Take into account the surrounding conditions:
The welding may not be performed under direct sun rays influence, use a welding umbrella
if necessary.
•
If the surrounding temperature is under 5° C, measures have to be taken:
Use a welding tent or preheat the pipe ends if necessary.
Path measuring system
