Ku nst sto ffschweißtec hni k
WIDOS
Einsteinstr. 5
Phone +49 (0) 71 52 99 39 - 0
W. Dommer Söhne GmbH D-71254 Ditzingen-Heimerdingen Fax
+49 (0) 71 52 99 39 - 40
Website: www.widos.de
Email: info@widos.de
03.03.2009
Working Instructions WIDOS PSM 15 with pneumatic clamping
Page 18 of 33
5. Starting and operating
The instructions of this chapter are supposed to guide you in the operation of the machine and
lead you during the appropriate starting of the machine. This includes:
- the safe operation of the machine;
- using all the possible options of the machine;
- economic operation of the machine.
5.1. Starting
•
Remove the packaging.
•
Connect the heating element to the local mains supply (230 V / 50 Hz / 16 A).
•
Connect one pneumatic hose to the local compressed air supply (6 – 8 bar) and to the
connector of the service unit (chapter: 4.3)
The machine only has to be introduced and used by skilled persons. For their
qualification they can pass an exam of plastic welding according to DVS and
DVGW.
•
In dangerous situations for man and machine you have to immediately disconnect the
machine from the mains plug.
•
Having finished the welding work and during intervals you have to turn off the machine.
Furthermore you have to control that no unauthorized person can use the machine
•
Protect machine against humidity!
•
The use on building sites is only permitted when respecting VDE 0100 and using current
distribution with FI-safety-switch.
Carefully install electric cables (danger of stumbling)!
•
Pay attention to environmental conditions:
−
The welding process may not take place in case of direct insulation.
•
If local temperature is under 5° C the following measures have to be taken:
−
if necessary heat up sheet ends.
•
Take measures against rain, wind and dust.
