Ku nst sto ffschweißtec hni k
WIDOS
Einsteinstr. 5
Phone +49 (0) 71 52 99 39 - 0
W. Dommer Söhne GmbH D-71254 Ditzingen-Heimerdingen Fax
+49 (0) 71 52 99 39 - 40
Website:
www.widos.de
Email: info@widos.de
03.03.2009
Working Instructions WIDOS PSM 15 with pneumatic clamping
Page 24 of 33
7. Maintenance / Storage / Transport
7.1. In general
•
Damaged parts have to be immediately replaced, in particular be careful with electric parts,
dirt and humidity are very good conductors.
•
In case of repair do only use original
WIDOS – spare parts
.
•
Control resp. refasten all screwed connections if loose
every 3 months
.
All maintenance and repair work must be carried out with the machine being switched
off.
Thereby, the machine has to be protected against unintentional activation.
Prescribed maintenance and repair works are to be carried out in due time. DVS
recommends repair works after one year.
Machines which are loaded above the average, the checking cycle should be
shortened. The works have to be executed by company WIDOS GmbH or by one of
its authorized representatives.
7.2. Clamping elements
In order to warrant a long lifetime, threaded spindles and joint pieces for clamping the sheets
should be regularly cleaned and greased.
7.3. Cleaning the machine
The materials you use for cleaning the machine have to be properly treated and have to be
appropriately disposed, especially:
•
when cleaning with solvents
•
when lubricating with oil and grease.
7.4.
Service unit
Upon reaching a condensation level of appr. 10 mm below the filter element:
Open the outlet screw counterclockwise (seen from below). Thereby, the condensate is
released.
In case of minor flow despite unchanged pressure settings:
Exchange the filter cartridge:
•
Ventilate equipment and device.
•
Turn filter jacket counterclockwise.
•
Only seize the new filter cartridge by its lower end.
•
Mount individual parts in reverse order.
•
Restarting see „adjusting“ (chapter: 4.3)
