All information, illustrations and specifications in these Operating Instructions are based on the latest information available at the time of
publication. We reserve the right to make design changes at any time without prior notification
18
2.0. Assembly
2.4. Fitting the lighting system
Insert the electrical cable into the hole (A) on the
hopper gate frame and thread it to the right.
Secure the side lamp (B) with the bracket on the
right-hand side to the hopper gate reinforcement
(C) using the hexagon bolt (D) provided.
Route the two cables in the hopper gate
reinforcement towards the rear.
Route the electrical cable with the 7-pin connector
along the hydraulic lines and towards the front and
fix it in place using cable ties.
Secure the long bracket (E) on the right-hand side
at the rear of the hopper gate reinforcement using
the hexagon bolt (F) provided. Secure the socket
(G) to the bracket and connect the two cables as
shown in the connection diagram.
To secure it at the bottom, drill a hole through the
rear wall of the hopper gate to match the bracket.
Secure the bracket at the bottom of the hopper
gate.
Secure the short bracket (H) on the left-hand side
at the rear to the hopper gate reinforcement using
the hexagon bolt (K) provided.
Screw the lighting carriers to the two brackets.
Connect the connector to the socket.
