All information, illustrations and specifications in these Operating Instructions are based on the latest information available at the time of
publication. We reserve the right to make design changes at any time without prior notification
38
8.0. Maintenance
8.10. Lubrication
– general information
Before starting any
lubrication work, the engine
must be shut down and the
ignition key removed.
Lubricate more often than
specified if necessary.
All exposed machine parts,
thread spindles and guides
should have a permanent, thin
coating of oil.
Clean lubrication nipple
prior to lubrication.
Wipe off any grease that
emerges.
Prior to operation after a
long out-of-service period,
lubricate the entire
machinery and perform the
maintenance tasks.
8.10.1. Lubrication (daily)
Remove dirt from profile
tubes and protective tubes.
Apply grease to inside of
outer sliding profile.
Lubricate points marked on
the illustration by arrows on
a daily basis.
Prior to all long out-of-
service periods, clean and
lubricate cardan shaft.
