All information, illustrations and specifications in these Operating Instructions are based on the latest information available at the time of
publication. We reserve the right to make design changes at any time without prior notification
28
6.0. Maintenance
6.1. General
ATTENTION!
During all works on and
around the machine, the
motor has to be switched
off and the ignition key
has to be taken out.
-
Repair, maintenance and
cleaning work as well as
the elimination of
malfunctions should
principally be done only
with the drive switched
off and the engine shut
off. Withdraw ignition key
.
-
The centrifugal mass may
cause the blower to run
on. Do not move too near
to the machine during this
time. Work can only be
continued when the device
is at a standstill.
-
Machine maintenance
involves not only
lubrication but also
cleaning. After completion
of work, the machine
should be washed and
thoroughly checked over.
-
Use
only original parts
.
Third-party parts often do
not match the required
quality and thus endanger
your safety. Moreover, the
sustained warranty and
recognition of justified
warranty claims can only
be guaranteed, if you
exclusively use
original
parts from Wiedenmann
.
We expressly point out to
you that non-original
parts that have not been
delivered by Wiedenmann
also have not been
approved and released by
Wiedenmann. The
installation and/or use of
such products may actually
have a negative impact on
the constructional
properties of your vehicle
and thus may affect the
active and/or passive
safety. Damages arising
from the use of non-
original parts are
excluded from the scope of
the manufacturer’s
liability.
-
Welding work on load-
bearing parts must be
carried out in accordance
with recognised welding-
technology methods.
-
Upon completion of
maintenance work,
reinstall all protective
devices.
6.2. Cleaning
The main point to be cleaned is
the air intake grid.
When using compressed air or
high-pressure cleaners be careful
that no water, dirt or other
impurities can penetrate the gear
or the bearing.
