Snow Master Vario Flex 3370
11 Maintenance
02 | 2019
3370 99 01 – 003
59
11.6.
Cleaning the device
Checking and cleaning the equipment on a regular basis will help you detect the following damage at an early stage:
Loose components
Damaged cables or lines
Wear and unintended collision points.
ATTENTION!
Material damage caused by aggressive cleaning products.
Do not bring plastic and sealing elements in contact with aggressive fluids
(e.g. carbon tetrachloride, tri, benzene, caustic solutions,acids etc.)!
CAUTION!
Environmental pollution caused by dripping oil.
Bind drops of oil with a binding agent and dispose of it according to the regulations!
Eliminate the cause!
WARNING!
Failure to wear personal protective equipment poses a risk of injury.
Wear personal protective equipment.
See Section 3.6.10 "Personal protective equipment"
Clean all dirty parts with water.
Clean all signs and markings with a dry cloth.
Apply spray oil to the equipment after cleaning.
11.7.
Replacing the wear strips
11.7.1.
Plastic cutting edges
Plastic scraping edges are easy going on the road surface and
are not as noisy.
Fitting new wear strips
Fit new wear strips (1) in hole row (A) and secure
them in place with countersunk screws (2), retaining
strips (3), washers (4) and self-locking nuts (5).
