All information, illustrations and specifications in this manual are based on the latest information
available at the time of publication. We reserve the right to make changes at any time without notice.
39
7.0. Operation
7.4. Setting scraper
Adjust the 2-part scrapers on
the front roller and the rear
roller to prevent debris from
adhering to the rollers.
Set the scraper blade
approx. 0.04 in. from the
roller.
Front roller
Loosen hex nuts (A).
In the attached recesses, the
scrapers are to be pushed with
a screwdriver into the desired
position.
Afterwards, re-tighten all the
hex nuts (A).
Rear roller
Bring the rear roller into the
upper position
(see Chapter 6.6.).
Loosen the hex bolts (B).
Move scraper into position and
re-tighten all the hex bolts (B).
7.5. Clamp fastener for hood
The clamp fasteners on the side
are to be checked at regular
intervals.
To adjust the hex nut
(A)
,
loosen and turn the eyelet
(B)
by 180 degrees.
The clamp fastener
(C)
must
always be secured with a cotter
pin
(D)
.
