Configuration and setup
Wieland Electric GmbH | BA000870 | 06/2020 (Rev. A)
13
Furthermore, you can also use CLI interface through Console port/Telnet/SSH to configure
wienet
SDS
. Enable the
Access Control
(refer to
System Setup > Admin Settings
), then you can use CLI in-
terface.
Figure 6: Access control
Note that if you change the IP address, you need to restart
wienet SDS
.
Configuring automatic IP assignment with DHCP
A DHCP server can automatically assign IP addresses, Subnet Mask and Network Gateway to LAN in-
terface. You can simply check the
DHCP (Obtain an IP Automatically)
checkbox in the
Network Set-
ting
dialog using Wieland's
wienet Manager
, a device management utility, and then restart the de-
vice. Once restarted, the IP address will be configured automatically.
NOTI C E
