Operation
38
Wieland Electric | BA000580 | 6/2009 (Rev. A)
8
Operation
Before you can teach-in transmitters to buttons and other controls, the configuration of the
device with the LNS Plug-In must be completely finished. Document the assignments to
the channels.
The button numbers stated refer to the illustration on page 14.
8.1
Teach-in of transmitters (Learn; e.g. button)
1.
Set the required LON-NV number (0-55) using the channel selector switches (4,5).
2.
Check the assigned reaction in the LON network using the Test button (6).
3.
Press the Learn button (7) and keep it pressed for longer than three seconds; the green
LED (10) flashes.
4.
Let the transmitter to be taught-in transmit three times within two seconds (e.g. press
the button three times in succession).
5.
If the radio signal corresponds to the type parameterised with the LNS Plug-In, it will
be taught-in on the channel set by the channel selector switches.
6.
The gateway exits the programming mode automatically and the green LED (10) goes
out.
7.
Test whether the required function is correct after the teach-in.
You can teach-in other transmitters in the same way.
8.2
Deletion of assignments (Clear)
The LON bus and power supply must be present for the deletion. There are three deletion
variants:
1.
Deletion of a single ID from the complete gateway.
2.
Deletion of all ID's from a channel.
3.
Deletion of all ID's from all channels, restoration of the factory settings.
8.2.1
Variant 1: Delete a single ID
1.
Press the Clear button (7) and keep it pressed for longer than three seconds; the red
LED (8) flashes.
2.
Transmit an ID three times within two seconds (e.g. press a button three times in
succession) and this ID will be deleted from all channels.
3.
The gateway exits the clear mode automatically and the green LED (8) goes out.
4.
Check and document the changes.
8.2.2
Variant 2: Delete all IDs from one channel
1.
Set the channel to be cleared using the channel selector switches.
2.
Press the Clear button (7) and keep it pressed for longer than three seconds; the red
LED (8) flashes.
3.
Press the Clear button (7) again and keep it pressed for longer than three seconds. This
deletes all IDs from the channel.
4.
The gateway exits the clear mode automatically and the red LED (8) goes out.
5.
Check and document the changes.