14033590.01 10/2014 GB/D
32
WIKA operating instructions model CS4S
GB
7.8 Display of the manipulated variable
■
After pressing the MODE key for approx. 3 seconds during normal actual value/set point
display, the manipulated variable is shown on the lower SV display.
■
So long as the manipulated variable is shown, the furthest right of the decimal points will
blink every 0.5 seconds.
■
Once the MODE key has been pressed again, the normal actual value/set point display
is once more shown.
8. Descriptions of the operating characteristics
8.1 Standard control mode, control output 1
Heating action (indirect)
Cooling action (direct)
Control output
Proportional band
Proportional band
Set point
Set point
Relay
(-R/)
Switching status dependent upon the control deviation Switching status dependent upon the control deviation
Logic level (-S/)
Switching status dependent upon the control deviation Switching status dependent upon the control deviation
Analogue
current signal
(-A)
Changes will occur continuously in accordance with
the control deviation
Changes will occur continuously in accordance with
the control deviation
LED Control
Output 1 (OUT1)
in this range, ON or OFF
ON
OFF
ON
OFF
+
─
+
─
+
─
+
─
+
─
+
─
DC 12 V
DC 12/0 V
DC 0 V
DC 0 V
DC 0/12 V
DC 12 V
+
─
+
─
+
─
+
─
+
─
+
─
DC 20 mA
DC 20 ... 4 mA
DC 4 mA
DC 4 mA
DC 4 ...20 mA
DC 20 mA
ON
OFF
OFF
ON
8. Descriptions of the operating characteristics
