29
WIKA operating instructions process transmitter, model UPT-2x
14111166.02 04/2015 EN/DE
EN
8. Configuration via display and operating unit
8.1.3
Configuring the volume measurement
Requirement
■
Length unit for the filling height is known
■
Medium density is known
■
Characteristic curve of the tank is known (→ see chapter 8.1.4
“Characteristic curves”)
1.
Open the operating menu with [↵].
Select “Basic setting” and confirm with [↵].
2.
Select “Application” and confirm with [↵].
3.
Select “Level” and confirm with [↵].
4.
Select “Unit” and confirm with [↵].
5.
Select length unit and confirm with [↵].
»
Length unit is set.
6.
Select “Density” and confirm with [↵].
7.
Select “Density unit” and confirm with [↵].
8.
Select density unit and confirm with [↵].
»
Density unit is set.
9.
Select “Density value” and confirm with [↵].
10. Setting the density of the medium.
Set digits using [▲] [▼] and confirm with [↵].
»
The cursor moves to the next digit.
»
Repeat for each digit.
»
Density value is set.
11.
Go back two menu levels using [ESC].
Select “Volume” and confirm with [↵].
12.
Select “Scale in” and confirm with [↵].
