OPTIMUM ROUND ABOVE / IN-GROUND POOL
Section 1
Section 2
Step 1
– Create a Foundation
11
Establish the pool circumference by driving a stake into the
ground at the center of the site.
Attach one end of a string to the center stake, measure the string
out to equal the pool radius, plus an additional 12 inches for
clearance. Holding the string taut, walk the outer perimeter of
your pool site while marking the circle with either spray paint, a
lawn edger or white powder.
Remove all sod, weeds and other growth from within the circle.
Dig to the depth the pool will be installed for below-grade
installations. Find the lowest spot within the pool area and level
the surrounding ground to that lowest spot. Dig higher areas
down to this level.
DO NOT
add dirt to raise the low areas, as the
weight of the filled pool will cause uneven settling.
NOTE:
The pool floor may be dug deeper, sloping to the center
of the pool for use with an expandable liner.
Remove protruding roots, stones and other sharp objects that
could damage the pool. Tamp down ground with square tamper.
IN-GROUND INSTALLATIONS: It is recommended that the
top of the pool be 2” - 6” above the surrounding area.
Confirm the site is level and flat using a long straight board or
2x4 and a carpenter’s level or transit. Continue to remove high
areas of ground if needed.
1.1
1.2
1.1
1.2
ABOVE GROUND / IN-GROUND
Summary of Contents for Optimum Pool Round 95-0770
