3
Installation Procedure
Gate Stop
(SP0127)
It is recommended to start installation of
gate from the pivot post and work towards
the receiver post. The gas springs to be
the last items assembled onto the gate.
1. Position pivot post in desired location.
Before anchoring to floor, place gate
stop on top of base plate aligned with
holes along inside edge of base plate,
as shown. Utilize anchors to secure
gate stop in place.
NOTES:
Dimension A to match on page 7.
Refer to the assembly drawing # SP0103
at the end of these instructions to aid in
assembly of the gate.
see
pa
ge 7
Anchors not provided
by Wildeck, use Ø3/8"
anchors
Pivot Post
(SP0110)
