8
Left Handlebar Switches
Dimmer Switch
• When the headlight is in the on position you have two options on the switch:
1. high beam
2.low beam
Turn Signal
• Use the turn signals when turning, pulling over or changing lanes to indicate to the
other motorist your intention. Push the switch to the right to turn right or push it to the left
to turn left. The switch will automatically return to the center but the light will not go out
until you push in on the switch.
Horn Button
Right Handlebar Switches
Light Switch
1. All lights are off.
2. Taillight, licenses plate light and the dash lights are on.
3. Headlight, taillight, licenses plate light and the dash lights are on.
Electric Start Switch
Turn the key on then push this button to start the bike.
NOTE:
• Make sure all accessory switches are in the off position.
• Apply the rear brake prior to starting the engine.
• Never exceed 4 seconds when using the starter switch.
• Release the starter switch immediately after the engine starts.
• Do not apply the starter switch while the engine is running.
Front Brake Lever
• The front brake lever is located on the right handlebar. Use both brakes when stopping,
if the front wheel skids let off immediately and reapply.
1.
2.
3.
7
Pre Ride Check
Fuel
• Check before you ride. Do not over fill the tank. Fuel capacity: 2gal.
Throttle
• Turn the throttle and make sure that it turns smoothly, freely and returns to idle
when released.
Checking the Engine Oil
• Place the scooter on level ground on the center stand.
• If the oil level is below the designated area, add 5W50, 10W50 or 15W50 synthetic oil
until the level is between the lower and upper marks on the dipstick. Do not overfill.
Note:
Be sure the scooter is level when checking the oil. A slight tilt to the left or right can
cause a false reading.
Steering Inspection
• Place the scooter on a stand so that the front wheel is off the ground. Hold the lower
end of the front fork and try to move it forward and backward. If any free play can be felt
consult a mechanic regarding the steering bearings.
NOTE:
Securely support the scooter
so there is no danger of it falling over.
Final Drive Oil
• Recommended Oil: 5W50, 10W50 or 15W50 synthetic engine oil.
Lights, Signals, Switches and Handlebars
• Check all lights, meters, indicator lights and electrical connections to make sure they
are all in proper working condition.
• Check the handlebars make sure they turn both ways smoothly.
Tires
• Always check the tires before riding, be sure they are in good condition, check for nails,
glass or any other items that may puncture your tire. Check for cracks in the side wall. If
there are any problems with the tires please replace immediately.
Tire Pressure
• To ensure maximum performance and safe operation please check the tire
pressure before riding. Do not over inflate your scooters tires because the
handling characteristics are different when the maximum air pressure has
been exceeded.
• Front Tire Pressure: 35 psi (cold)
• Rear Tire Pressure: 40 psi (cold)
Dipstick
Drain Plug
Oil Filler Bolt
